Table of Contents
Advertisement
Orion
Revision 3.1
21 May 2020
Wrap Setting Screens
Wrap Settings Screen
Note:
Figure 3 - 10
The Wrap Settings
Screen
STATE 1
TOP WRAPS
BOTTOM WRAPS
CARRIAGE UP SPEED
To adjust the wrap settings, you must be logged in. Press the login
button in the bottom left corner of the screen. Enter ADMIN then
press the checkmark, then X to close the keypad.
This is the Wrap Settings screen. This screen allows you to set the number of top and bot-
tom wraps and the speed percentage of the carriage up and down travel. You may also
choose wrap pattern options such as, Wrap Bottom First, Wrap Top First, Low Speed/
High Speed, Unstable Load Enabled or Disabled, Autoheight Enabled or Disabled, or
Film Fault Enabled or Disabled. You can view each pattern settings on the Recipe Viewing
Screen, see "Sentry Carriage Recipe Viewing Screen" on page 3 - 17.
Table 3-6. The Wrap Settings Screen Button Descriptions
Press this button to set the number of top wraps applied to the load. Parameters are
1-20.
Press this button to set the number of bottom wraps applied to the load. Parameters
are 1-20.
Press this button to change the speed of the carriage on the upward move, in terms
of percentage. Min - 5% Max - 100%
DESCRIPTION
Machine Manual
Sentry HP/ LP Flex Stretchwrapper
System Operation
STATE 2
Page 3-11
Advertisement
Table of Contents
