Table of Contents
Advertisement
Orion
Revision 3.1
21 May 2020
Start Settings Screen
Figure 3 - 26
The Start Settings
Screen
STATE 1
START DELAY
AUTOMATIC RESTART
DISABLED
AUTOMATIC RESTART
CYCLES
AUTOMATIC RESTART
DELAY
BACK
This is the Start Settings screen. On this screen, you may set the amount of time, in milli-
seconds that the start button must be pressed before the machine starts. You can also set
the automatic restart parameters.
Table 3-22. The Start Delay Screen Button Descriptions
DESCRIPTION
Press this button to modify the Start Delay value, in terms of milliseconds. This
value determines the amount of time that the Start pushbutton must be pressed
before the machine will start. Min - 500 ms Max - 5000 ms
Press this button to enable or disable automatic
restart mode.
Press this button to set the number of automatic restart cycles.
Press this button to modify the Automatic Restart Delay value, in seconds. This
value determines the amount of time that the machine waits between automatic
restart cycles.
Press this button to go to the Machine Setup screen.
Machine Manual
Sentry HP/ LP Flex Stretchwrapper
System Operation
STATE 2
AUTOMATIC RESTART
ENABLED
Page 3-31
Advertisement
Table of Contents
