Table of Contents
Advertisement
Orion
Revision 3.1
21 May 2020
System Operation
3.
Operating Procedures
How to Start and Shut Down Your Wrapping System
Note:
Figure 3 - 1
Sentry LP HMI
Do not use extension cords. Plug your Flex Stretch-wrapper directly
into an outlet.
POWER SWITCH
Located on the panel door, the lockable power switch has two settings:
•
ON - connects a power source to the machine.
•
OFF - disconnects the power source.
START AND EMERGENCY STOP SWITCHES
•
Press the START button to gain Control Power prior to starting.
•
The START switch is used to start the cycle once the load is available.
•
The cycle may be stopped at anytime by pressing the E-STOP button.
Sentry HP/ LP Flex Stretchwrapper
HMI (Human Machine Interface)
Start/ Reset Button
E-Stop Button
Power Switch
Machine Manual
System Operation
Page 3-1
Advertisement
Table of Contents
