Table of Contents
Advertisement
Machine Manual
Sentry HP/ LP Flex Stretchwrapper
System Operation
Machine Setup Screen
Figure 3 - 25
The Machine Setup
Screen
Table 3-21. The Machine Setup Screen Button Descriptions
STATE 1
SELECT SENTRY
CARRIAGE
SELECT ORION
CARRIAGE
SELECT TURNTABLE
INSTA-CUT DISABLED
DEFAULT SECURITY
START SETTINGS
FACTORY DEFAULTS
MAXIMUM SPEED
Page 3-30
This screen is used when setting up the initial machine configuration. The technicians who
assembled you machine already set the type of machine you have on this screen. You will
not need to make any changes on this screen in day-to-day use.
DESCRIPTION
Press this button to select the Sentry Carriage.
Press this button to select the Orion Carriage.
Press this button to select that the machine is a turn-
table machine.
Press this button to activate or de-activate Insta-
Cut.
Press this button to go to the Security Settings Screen. See "Maintenance Prompt"
on page 3 - 8.
Press this button to go to the Start Settings Screen. See "Start Settings Screen" on
page 3 - 31.
Press this button to go to the Factory Defaults Screen. See "Factory Defaults
Screen" on page 3 - 32.
Press this button to go to the Maximum Speed Screen. See "Maximum Speed
Screen" on page 3 - 33.
Orion
Revision 3.1
21 May 2020
STATE 2
SELECT SENTRY
CARRIAGE
SELECT ORION
CARRIAGE
TURNTABLE
SELECTED
INSTA-CUT ENABLED
Advertisement
Table of Contents
