Operating Several Production Units At One Access Point; Connecting To The Pc Via The Wireless Interface - Dentsply Sirona CEREC Primemill Operating Instructions Manual

5 Installation and startup
5.4 Commissioning
32
5.4.6.6

Operating several production units at one access point

For the operation of several production units on one access point, you
will also require the following components:
● 1x LAN switch (e. g . Netgear ProSave 5 Port Gigabit Switch, Model
GS 1 05)
● 1x LAN network cable (10 m , order No.: 61 51 521).
A
10m
1. Connect the LAN connection A of the MC XL production unit or B of
the Primemill production unit with the LAN switch using the 10 m
LAN network cable provided.
2. Connect the access point with the LAN switch using the additional
10 m LAN network cable.
Ä Now, all production units connected to the LAN switch can be
operated via WLAN.
5.4.6.7 Connecting to the PC via the wireless interface (optional)
The CEREC acquisition unit has one of the following wireless modules
installed:
● CEREC Radio Device
– Installation kit: 65 42 521
– Retrofit kit: 65 43 073
or
● Höft & Wessel HW 8614/F2
– No longer available! Observe the following information:
IMPORTANT
The conversion from Höft & Wesel to the CEREC Radio Device was
performed in multiple stages. The first deliveries of CEREC Radio
Device to markets with approval took place in July 2015.
Acquisition units and production units can only work with one wireless
module system or the other. This means that an additional production
unit or acquisition unit that is acquired by existing customers which
need to be connected wirelessly to existing systems will require the
existing systems to be retrofitted in order to work with the new
CEREC Radio Device.
Operating Instructions CEREC Primemill
10m
Accesspoint
LAN Switch
Dentsply Sirona
B
10m
67 19 681 D3439
D3439.201.01.01.02 09.2019