Switching The Units On - Dentsply Sirona CEREC AF Operating Instructions Manual

6 Installation and startup
6.5 Commissioning
42
6.5.3

Switching the units on

Prior to initial startup
Prior to initial startup, the wireless keyboard stick must be connected to
a USB port on the rear of the PC. As long as Windows has not yet been
activated, the USB port at the front of the PC is not detected as such.
You can reconnect the stick to the front of the PC following activation.
First startup
1. Switch on the PC for the first time. When activating the Windows
settings, you will be prompted to make a language selection. This is
a one-off procedure. This selection cannot be reset or changed at a
later date.
2. Set the monitor to its maximum resolution or the resolution
recommended by Windows.
3. Install the CEREC SW software on the CEREC AF /AI PC.
For CEREC AF Connect/AI Connect, download the Sirona Connect
software from the Sirona homepage. Confirm the firmware update
for the CEREC Omnicam with "YES" .
Following initial installation
Follow the steps below for proper operation after initial installation:
1. Switch the PC on with the ON/OFF button.
NOTE
Possible data loss and PC malfunction:
Switching the PC off at the ON/OFF button during operation may
cause data loss and PC malfunctions.
➢ Always switch the unit off as described in the chapter "Switching
the units off [→ 44]".
2. Switch the monitor on.
Ä When the PC has started up and the coupling box is supplied
with voltage, the illuminated green LED on the camera cradle
indicates that the camera is ready for use. As long as the PC is
switched off, the camera and heater are not supplied with
power.
NOTE
The two USB ports on the front of the PC are also supplied with
power, if necessary, when the PC is switched off (depending on PC
hardware version).
➢ Always connect the coupling box to a USB power on the rear of
the PC.
3. Switch the milling unit on (see the Operating Instructions for the
milling unit).
4. After loading the operating system, start the "CEREC SW"
application by double-clicking on the "CEREC SW" button. Make
sure that the CEREC Omnicam is already connected when starting
"CEREC SW" . Subsequent disconnection and re-connection is then
possible without having to restart the "CEREC SW" .
Dentsply Sirona
Operating Instructions (valid for Canada)
66 37 487 D3652
D3652.201.01.21.02 03.2021