Table of Contents
Advertisement
Result
The unit reverts to factory-installed firmware. Event scripting does not start if the unit is
powered on in this mode. All user files and settings such as drivers, adjustments, and IP
settings are maintained.
NOTE:
power to the unit.
Reset All IP Settings
This mode resets all IP settings to factory defaults.
Activation
To reset all IP settings:
1.
Hold down the
the Reset LED (
2.
Release and press the
Nothing happens if the momentary press does not occur within 1 second.
Result
Resets All IP Settings mode:
•
Sets the IP address back to factory default (
•
Sets the subnet mask back to factory default (
•
Sets the gateway address to the factory default (
•
Sets all other IP settings, addresses, and domain and host names back to factory default
•
Turns DHCP off
•
Reset to Factory Defaults
This mode resets all IP settings and touchpanel settings, including passwords, to factory
defaults and removes all configurations. It allows you to start over with configuration and
uploading.
NOTES:
•
The factory configured passwords for all accounts on this device have been set to the
device serial number. Passwords can be changed during configuration. They are case
sensitive.
•
If the device is reset to default settings, the passwords are reset to the default
password, which is
Activation
To reset the unit to all factory default settings:
1.
Hold down the
(once at 3 seconds, again at 6 seconds, again at 9 seconds).
2.
Release and press the
Nothing happens if the momentary press does not occur within 1 second.
Result
Reset to Factory Defaults mode performs a complete reset to factory defaults (except the
firmware).
Does everything Reset All IP Settings mode does.
•
Removes touchpanel user interface layout and configurations.
•
Resets all touchpanel settings to factory default.
•
To return the unit to the firmware version that was running prior to the reset, cycle
button (see
figure
Reset
F
) blinks twice (once at 3 seconds, again at 6 seconds).
button momentarily (for <1 second) within 1 second.
Reset
extron (for either admin or user ).
button for about 9 seconds until the Reset LED blinks three times
Reset
button momentarily (for <1 second) within 1 second.
Reset
2,
on page 5) for about 6 seconds until
G
192.168.254.251
)
)
255.255.255.0
)
0.0.0.0
TLI Pro 101 • Reference Material
31
Advertisement
Table of Contents
