Extron electronics TLI Pro 101 User Manual page 27

Input Audio and Video
The two pairs of buttons on the right of the screen allow three
settings to be toggled On and Off.
— Enables 2CH PCM support on input EDID.
Input Audio
Input Audio is On by default.
HDCP Authorize — When this setting is enabled,
HDCP-encrypted input signals pass to the output display.
HDCP Authorize is On by default.
— Press
Aspect Ratio Fill
fills the entire screen. Press
Follow
the aspect ratio of the input signal.
— Press
Adjust Picture
dialog to adjust the input video picture. Press
, or to adjust those values.
Contrast Detail
read-only and cannot be edited.
— to (default
Brightness 0 127
— to (default
Contrast 0 127
— to (default
Detail 0 127
(status only)
Active Pixels
Active Lines (status only)
— Allows the current values to be saved as
Presets
a preset and opens the Presets
below).
— Returns the picture values to their
Default all
default settings.
— Closes the dialog.
Exit
Presets
# Input Name
1 HDMI Blu-ray
2 HDMI Blu-ray 2
3 N/A Preset 03
4 N/A Preset 04
5 N/A Preset 05
6 N/A Preset 06
7 N/A Preset 07
8 N/A Preset 08
Figure 18.
Presets Dialog
— Highlight one of the presets and press
Save
and Detail settings to that preset.
— Highlight one of the presets and press
Recall
Brightness, Contrast and Detail with those saved by that preset.
Rename — Highlight one of the presets and press
— Highlight one of the presets and press
Clear
preset.
to stretch the image so that it
for the image to maintain
to open a
Adjust Picture
Brightness
Active Pixels
)
64
)
64
)
64
dialog (see figure 16,
Save
Recall
Rename
Clear
to save the current Brightness, Contrast,
Save
Recall
Rename
to clear the values stored by that
Clear
TLI Pro 101 • On-screen Menus
Input Audio and Video
Input
On
Audio:
HDCP
On
Authorize:
Aspect
Fill Follow
Ratio:
Adjust Picture
,
and are
Active Lines
Brightness 64
64
Contrast
64
Detail
Active Pixels 1280
Active Lines 720
Default
Presets Exit
All
to replace the current settings for
to assign a new name to the preset.
Off
Off
20