Extron electronics TLI Pro 101 User Manual page 13

Power (see figure 2,
A A
connector from the provided 12 VDC power supply to the power supply socket on the rear
panel. Figure 3 shows how to wire the connector. Ensure the connections have the correct
polarity.
Smooth Ridges
A A
Power Supply
Output Cord
Figure 3.
Wiring the Power Connector
WARNING: The two DC output cables must be kept separate from each other
while the power supply is plugged in. Remove power before wiring.
AVERTISSEMENT :
uns des autres tant que la source d'alimentation est branchée. Coupez
l'alimentation avant d'effectuer les raccordements.
CAUTION:
Risk of Explosion if the battery is replaced by an incorrect type.
Dispose of used batteries according to the Instructions.
: Risque d'explosion. Ne pas remplacer la pile par le mauvais type de
ATTENTION
pile. Débarrassez-vous des piles utilisées selon le mode d'emploi.
ATTENTION:
•
Do not power on the interfaces or control processors until you have read the
Attention on page 7 (12 VDC power supply) or on
• Ne branchez pas les interfaces ou les contrôleurs avant d'avoir lu les
en garde page 7
PoE).
NOTES:
•
The TLI Pro 101 ships with a 12 VDC, 1.5 A power supply and is also Power over
Ethernet (PoE 802.3af, class 3) compliant. The power injector must be purchased
separately.
• If a 12 VDC power supply and a PoE power injector are both connected to
the TLI Pro 101, the power injector takes precedence. If a PoE power loss
is detected, the interface switches seamlessly to the 12 VDC supply without
needing a system reboot.
, on page 5)— Connect the 2-pole, 3.5 mm captive screw
-
SECTION A–A
Tie Wrap
-
Captive Screw
Connector
Les deux câbles de sortie CC doivent être séparés les
(source d'alimentation 12 VCC) ou
TLI Pro 101 • Panel Features
3/16" (5 mm) Max.
page 11 (power injector).
mises
(injecteur
page 11
6