Cisco ONS 15454 Series Procedure Manual page 37

Figure 5-13 Using the Patch Panel Latches to Slide the Patch Panel Away from the Tray
Figure 5-14 MPO Cable
Figure 5-15 Rear View of the Patch Panel
Figure 5-16 Top View of the Patch Panel Bar
Figure 5-17 Front View of the Patch Panel
Figure 5-18 Deep Patch Panel Tray
Figure 5-19 Deep Patch Panel Port Wavelengths
Figure 5-20 40-Channel Patch Panel Tray, Side View
Figure 5-21 40-Channel Patch Panel Tray, Top View
Figure 5-22 40-Channel (15454-PP-80) Patch Panel Port Wavelengths
Figure 5-23 Managing Cables on the Front Panel
Figure 5-24 Fiber-Storage Tray
Figure 5-25 Y-Cable Protection Port Label
Figure 5-26 Y-Cable Protection Module Tray
Figure 7-1 Single-Span Topology
Figure 7-2 Point-to-Point Topology
Figure 7-3 Hubs with No Line Amplifiers
Figure 7-4 Hubs with Line Amplifiers
Figure 8-1 Network View of Nodes (Terminal or ROADM)
Figure 8-2 Installing the Raman Pump on a Single Span
Figure 8-3 Installing the Raman Pump on Multiple Spans
Figure 8-4 Selecting Spans for Raman Amplification
Figure 8-5 Setting Raman Calibration Parameter
Figure 8-6 Bidirectional Path Is Unchecked and MUX/DMUX Present Is Checked
Figure 8-7 Bidirectional Path Is Unchecked and MUX/DMUX Present Is Unchecked
Figure 8-8 Bidirectional Path Is Checked and MUX/DMUX Present Is Checked
Figure 8-9 Bidirectional Path Is Checked and MUX/DMUX Present Is Unchecked
Figure 8-10 Calibrating Raman Amplification
Figure 8-11 Calibrating Raman Amplification
Figure 8-12 Raman Amplification Results
Figure 8-13 Force Raman Calibration
Figure 9-1 Upgrade OCHNC Initialization—Completed
Figure 9-2 Upgrade OCHNC Initialization—Failed
Figure 9-3 Viewing the Provisionable Patchcords Table
Figure 9-4 Automatically Routing a VCAT Circuit
78-19286-01
5-82
5-83
5-83
5-84
5-86
5-87
5-100
5-101
5-105
5-106
7-11
7-12
7-12
7-13
8-9
8-15
8-16
8-17
8-19
9-73
5-88
5-89
5-91
8-6
8-7
8-7
8-8
9-39
9-40
9-41
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
5-81
8-11
8-12
8-13
8-14
Figures
xxxvii