Cisco ONS 15454 Series Procedure Manual page 95

Chapter 1 Install the Cisco ONS 15454 Shelf Assembly
•
NTP-G305 Unpack and Inspect the ONS 15454 Shelf Assembly
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
Complete the
Step 2
Continue with the
Step 3
page
Stop. You have completed this procedure.
DLP-G676 Unpack and Verify the ONS 15454 Shelf Assembly
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Step 1 When you receive the ONS 15454 system equipment at the installation site, open the top of the box. The
Cisco Systems logo designates the top of the box.
Step 2 Remove the foam inserts from the box. The box contains the ONS 15454 shelf (wrapped in plastic) and
a smaller box of items needed for installation.
Step 3 To remove the shelf, grasp both rings of the shelf removal strap and slowly lift the shelf out of the box.
Step 4 Open the smaller box of installation materials, and verify that you have all items listed in the
Tools and Equipment (ETSI)" section on page 1-5
section on page
Note
78-19286-01
BER tester for E1-N-14, E1-42, E3-12, DS3i-N-12, STM1E-12, and FMEC cards
This procedure explains how to unpack the ONS 15454 shelf assemblies
and verify their contents.
Pinned hex (Allen) key for front door
Required
Onsite
None
"DLP-G676 Unpack and Verify the ONS 15454 Shelf Assembly" task on page
"DLP-G677 Inspect the ONS 15454 Shelf Assembly" task on page
"NTP-G305 Unpack and Inspect the ONS 15454 Shelf Assembly" procedure on
1-7.
This task removes the shelf assembly from the package.
None
Required
Onsite
None
1-3.
The fan-tray assembly is shipped separately.
Required Tools and Equipment (ETSI)
or the "Required Tools and Equipment (ANSI)"
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
1-7.
1-8.
"Required
1-7