Figure 1-8 Positioning The Mounting Brackets For Deep Door Configuration - Cisco ONS 15454 Series Procedure Manual

Required Tools and Equipment (ETSI)
Figure 1-8
Front
Front
Repeat for the other side of the assembly.
Step 11
NTP-G3 Open and Remove the Front Door
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
Step 2 Complete the
If you are using an ETSI shelf, continue with the
Step 3
Only)" procedure on page
Backplane Covers (ANSI Only)" procedure on page
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
1-22
Positioning the Mounting Brackets for Deep Door Configuration
80 mm
Side View
This procedure opens and removes the front door to access the equipment.
Open-end wrench
Pinned hex (Allen) key
NTP-G306 Install the ONS 15454 Shelf Assembly, page 1-8
Required
Onsite
None
"DLP-G9 Open the Front Cabinet Compartment (Door)" task on page
"DLP-G10 Remove the Front Door" task on page
1-26. If you are using an ANSI shelf, continue with the
Chapter 1 Install the Cisco ONS 15454 Shelf Assembly
80 mm
1-24.
"NTP-G4 Open and Remove the FMEC Cover (ETSI
1-29.
1-23.
"NTP-G5 Remove the
78-19286-01