Cisco ONS 15454 Series Procedure Manual page 91

Chapter 1 Install the Cisco ONS 15454 Shelf Assembly
Warning This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. To see translations of the warnings that appear in
this publication, refer to the Regulatory Compliance and Safety Information document for the
appropriate Cisco chassis. Statement 274
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260.
Warning
Incorrectly connecting this equipment to a general-purpose outlet could be hazardous. The
telecommunications lines must be disconnected 1) before unplugging the main power connector or
2) while the housing is open, or both. Statement 1043
This unit is intended for installation in restricted access areas. A restricted access area can be
Warning
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1040
A readily accessible two-poled disconnect device must be incorporated in the fixed wiring.
Warning
Statement 1022
Note The ONS 15454 is suitable for mounting on concrete or other noncombustible surfaces only.
In this chapter, "shelf assembly" refers to the steel enclosure that holds cards and connects power, and
Note
"node" refers to the entire hardware and software system.
Required Tools and Equipment (ANSI)
You need the following tools and equipment to install and test the ONS 15454 ANSI shelf assembly.
Cisco-Supplied Materials (ANSI)
The following materials are required and are shipped with the ONS 15454 ANSI shelf (wrapped in
plastic). The number in parentheses gives the quantity of the item included in the package.
•
78-19286-01
#12-24 x 3/4 pan-head Phillips mounting screws (48-1004-XX, 48-1007-XX) (8)
Required Tools and Equipment (ANSI)
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
1-3