Replacing The Primary Codec - Cisco TelePresence System Series Hardware Upgrade Manual

Upgrading a CTS 3000 to a CTS 3200
•
•
•

Replacing the Primary Codec

Note the microphone outlets on the current primary codec. If there are three microphone outlets, replace
Note
the primary codec by completing the steps in this procedure. If there is one microphone outlet, bypass
this section and continue to the
To replace the existing primary codec with the new primary codec, complete the following steps:
Remove all cable ties holding the cables to the cable management bar. Take note of the organization of
Step 1
the cables.
Remove the cables from the codec. Label each cable with masking tape for identification as it is
Step 2
removed.
Remove and retain the screws that attach the codec's L-brackets to the Display structure Front feet.
Step 3
Remove the codec from the Display structure.
Step 4
Remove the L brackets from the codec.
Step 5
Remove the cable management bar from the codec. Retain the bar and the screws.
Step 6
Make a note of the MAC address of the new primary codec. The MAC address should be printed on a
Step 7
sticker on the codec. You configure Cisco Unified Communications Manager to use the new MAC
address in the
Cisco TelePresence System
6-30
The two left PDUs on the left accessory cabinet
The single right PDU on the right accessory cabinet
If present, the PDU on the center display structure
"Powering On the System" section on page
Chapter 6 Options for the Cisco TelePresence System 3000, 3010, 3200, and 3210
"Removing and Replacing the Camera Lenses" section on page
6-96.
6-33.
OL-16441-01