Configuring The Dmp Audio For Use With The Cts 1300; Cisco Telepresence Presentation Codec - Cisco TelePresence System Series Hardware Upgrade Manual

Cisco TelePresence Presentation Codec

Configuring the DMP Audio for Use with the CTS 1300

When you are not in a TelePresence call, the DMP feature allows you to use the DMP audio as the
secondary audio input source. To configure the DMP audio, complete the following steps:
Navigate to Troubleshooting > Hardware Setup > Other Devices.
Step 1
Click the DMP tab.
Step 2
Click the Start button.
Step 3
Step 4
•
•
To end DMP audio configuration, click Stop.
Step 5
The CTS 1300 retains the setting that you specify in this procedure.
If you encounter problems when setting up the devices in this section, refer to the "Troubleshooting the
Cisco TelePresence System" chapter of the
for your software release. The list of guides is available at the following URL:
http://www.cisco.com/en/US/products/ps8332/prod_maintenance_guides_list.html
Cisco TelePresence Presentation Codec
The Cisco TelePresence Presentation Codec (CTS-HFR-COLLAB) provides 30 frames per second (fps)
capabilities to support full-motion video presentations between Cisco TelePresence endpoints when
used with an auxiliary presentation display.
You must install an auxiliary display to enable the 30 fps feature. For the list of the auxiliary displays
Note
that are supported for use with Cisco TelePresence systems, refer to the
Cisco TelePresence System
connects auxiliary devices to the codec.
Cisco TelePresence System
5-4
Select the DMP radio button if you want the audio to play only during the following times:
When the system is not in a conference
–
During normal business hours
–
You define normal business hours with the Display on Time and Display on Duration fields in
Cisco Unified Communications Manager. For more information about configuring normal
business hours for your CTS 1100, refer to the
Configuration Guide for the Cisco TelePresence
Select the PC radio button if you want the audio to play at all times that the DMP source is active,
including during a conference and during non-business hours.
Select this option if you want to share audio from the DMP source during a conference.
for your software release. Note that Cisco does not supply the cable that
Chapter 5 Options for the Cisco TelePresence System 1300
Cisco Unified Communications Manager
System.
Cisco TelePresence System Release Administrator's Guide
Release Notes for
OL-16441-01