Adding A Cisco Telepresence Presentation Codec-Cisco Telepresence System 3000 And 3200 - Cisco TelePresence System Series Hardware Upgrade Manual

Chapter 6 Options for the Cisco TelePresence System 3000, 3010, 3200, and 3210
Key Part Description
5
M4x12mm Pan head screws
6
M8 washers
7-31 Not used
32 M4 x 12 screws
33
M4 washers
Adding a Cisco TelePresence Presentation Codec—Cisco TelePresence
System 3000 and 3200
To add the Cisco TelePresence Presentation Codec to your CTS 3000 or CTS 3200, perform the
following procedure:
Turn the power switches for the two left PDUs and single right PDU to the Off position.
Step 1
Note If there is an additional PDU that is mounted on the rear of the center display structure, power off that
PDU also.
Make sure all system power is turned off before beginning this disassembly.
Caution
Figure 6-4 PDU Location
Power
Your installation might differ from this diagram. There might be one PDU on the left side of the display
Note
structure, rather than two; in addition, there might be a PDU in the center rear of the display structure.
OL-16441-01
Part Number Qty
48-2426-01 10
49-1165-01 4
53-2907-01 4
53-2907-01 4
Cisco TelePresence Presentation Codec
Notes
Cisco TelePresence System
6-7