Cisco TelePresence System Series Hardware Upgrade Manual page 93

Hide thumbs Also See for TelePresence System Series:
Table of Contents

Advertisement

Chapter 6
Options for the Cisco TelePresence System 3000, 3010, 3200, and 3210
In European Union countries, use only devices that are fully compliant with the EMC Directive
Caution
[2004/108/EC].
Upgrading a CTS 3000 to a CTS 3200
The following are the summary steps that you perform to upgrade a CTS 3000 system to a CTS 3200
system. Detailed information about the steps you perform are referenced in these steps.
For room and other minimum installation requirements, refer to the
Note
Data
System 3200 Assembly, Use & Care, and Field Replacement Unit
The table segments are unstable during assembly. Use caution, and support all structures as required.
Caution
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
OL-16441-01
GEFEN EXT-HDMI-144 or EXT-HDMI-144-BLK
This model has an internal DIP switch with 7 switches. To access it you must remove 3 small screws
on the bottom of the unit and 3 on each side (total of 9 screws). You must also unscrew the HDMI
locking nuts (5 total) and the lock nut on the 5v DC power input jack. Top/Back should slide off,
DIP switch is opposite the HDMI input jack.
You must set the DIP switch to Mode 7 according to the manual. Switches 1, 2, and 5 must be set to
the ON position.
Connect the video (projector) input to the connector labeled HDMI 1. Connect any auxiliary
displays to subsequent outputs.
The manual for this product is located at
GEFEN EXT-HDMI1.3-144
This model has two buttons on the back labeled Reset and EDID. Pressing EDID switches the LED
light on the front between Int and Ext.
Set the EDID to Ext and connect the projector to the connector labeled HDMI 1. Connect any
auxiliary displays to subsequent outputs.
The manual for this product is located at
GEFEN GTV-HDMI1.3-144
This model, is similar to the EXT-HDMI1.3-144 and has two buttons on the back labeled Reset and
EDID.
Set the EDID to TV connect the projector to output port 1.
The manual for this product is located at
Sheet. For more information about installing a CTS 3200, refer to the
http://www.gefen.com/pdf/EXT-HDMI-144.pdf
http://www.gefen.com/pdf/EXT-HDMI1.3-144.pdf
http://www.gefen.com/pdf/GTV-HDMI1.3-144.pdf
Cisco TelePresence System 3200
Guide.
Cisco TelePresence System
Upgrading a CTS 3000 to a CTS 3200
Cisco TelePresence
6-27

Advertisement

Table of Contents
loading

Table of Contents