Adding An Auxiliary Control Unit - Cisco TelePresence System Series Hardware Upgrade Manual

Auxiliary Control Unit
Key Part Description
Audio/Video Expansion Unit, CTS-LIGHT-CTRL, 69-1989-01
8
M5 x 10mm pan head screws
9 Wood screws

Adding an Auxiliary Control Unit

To install the auxiliary control unit on your CTS 1000, complete the following steps.
Power off the system by unplugging the system power cord from the wall socket.
Step 1
Remove the front panel from the frame by completing the following steps:
Step 2
a.
b.
c.
d.
Figure 3-1 Removing the Front Panel From the Frame
Cisco TelePresence System
3-2
Remove the black speaker grille from the top of the front panel by grasping the sides until the pins
pop out of the holes.
Using a #3 Phillips screwdriver, remove the six screws next to the speaker (three on either side).
Pull the front panel away from the frame.
Disconnect the lighting unit from the PDU.
Chapter 3
Part Number Qty
48-0426-01 5
N/A 2
Options for the Cisco TelePresence System 1000
Notes
To be supplied by the customer.
OL-16441-01