Cisco TelePresence System Series Hardware Upgrade Manual page 62

Cisco TelePresence Presentation Codec
Step 3 Install the presentation codec into the cabinet by completing the following steps:
a.
Note
b.
Note
c.
Figure 5-3 Placing the Presentation Codec in the Cabinet
1
Cisco TelePresence System
5-6
Place the presentation codec into the left side of the cabinet.
Arrange the codec so that its power outlet is on the right as shown in
Cisco logo is hidden and the perforated grill on the codec faces the left side of the display
cabinet.
Slide the codec from the right to the left until the top of the codec slides past the spring-loaded posts
inside the cabinet.
In some cases, you might have to lift the posts and turn them counter-clockwise prior to
installation.
Turn the posts clockwise to lower the posts and lock the codec into place.
Chapter 5 Options for the Cisco TelePresence System 1300
Figure 5-3. Note that the
OL-16441-01