Cisco TelePresence System Series Hardware Upgrade Manual page 54
Hide thumbs
Also See for TelePresence System Series:
- User manual (51 pages) ,
- Quick reference manual (2 pages) ,
- Getting started manual (41 pages)
Table of Contents
Advertisement
Cisco TelePresence Presentation Codec
Step 5
Power on the system by turning the power switch on the PDU that is inside of the cabinet to the "ON"
position.
Write down the IP address that displays on the bottom right corner of the display screens. This is the
Note
address of the primary codec unit.
Step 6
Attach the cabinet cover to the cabinet by completing the following steps:
a.
Set the lower part of the cabinet cover into the slotted groove in the lower part of the cabinet.
b.
Align the tabs in the upper part of the cabinet cover with the slots in the upper part of the cabinet.
Rock the cover forward until the tabs go into the slots.
c.
Tip
If required, adjust the bar attached to the top of the light reflector by loosening the three screws and
raising or lowering the bar as required.
Cisco TelePresence System
4-8
Chapter 4
Options for the Cisco TelePresence System 1100
OL-16441-01
Advertisement
Table of Contents
