Diagnostics; Errors - W&H Lexa MN-111 Instructions For Use Manual

Diagnostics

CONTENTS
This section deals with the following subjects:

Errors

Troubleshooting
Emergency door opening
Errors
CHECKS AND ACTIONS
Notice: for any error not listed in this table, contact technical service.
Code
0xx Load cannot be considered sterile. See "End of a sterilization cycle" on page 53
Check if the mains switch or network circuit breaker is OFF.
Check if the mains cable is properly connected.
Switch the sterilizer OFF and ON.
Set date and time, then switch the sterilizer OFF and ON.
Ensure that the sterilizer fan is not blocked.
10x See error "13x to 16x" on the next page.
Lexa | Instructions for Use | MN-111 ENG Rev14 | 03/04/2023 | © W&H Sterilization Srl
Description Actions
Repeat the cycle.
If the problem persists, contact technical service.
Repeat the cycle.
If the problem persists, contact technical service.
69
74
80
69