Reinstalling The Jack And Tools - RAM 2500 2020 Owner's Manual

Pushing The Retainer Through The Center Of The
Wheel And Positioning It
3. Attach the lug wrench to the extension
tubes with the curved angle facing away
from the vehicle. Insert the extensions
through the access hole between the lower
tailgate and the top of the bumper and into
the winch mechanism tube.
Lug Wrench And Extension Tubes Assembled
And In Position
4. Rotate the lug wrench handle clockwise
until the wheel is drawn into place against
the underside of the vehicle. Continue to
rotate until you feel the winch mechanism
slip, or click three or four times. It cannot be
overtightened. Push against the tire several
times to ensure it is firmly in place.
NOTE:
The winch mechanism is designed for use with
the jack extension tube only. Use of an air
wrench or other power tools is not recom-
mended and can damage the winch.
R T J A
EINSTALLING HE ACK ND
1. Tighten the jack all the way down by
turning the jack turn-screw counter-
clockwise until the jack is snug.
2. Position the jack and tools into bracket
assembly. Make sure the lug wrench is
under the jack near the jack turn-screw.
Snap tools into bracket assembly clips.
Install the jack into bracket assembly and
turn the jack turn-screw clockwise until jack
is snug into bracket assembly.
IN CASE OF EMERGENCY
Jack And Tools Bracket Assembly
3. Place the jack and tool bracket assembly in
the storage position holding the jack by the
jack turn-screw, slip the jack and tools
T
OOLS
under the seat so that the bottom slot
engages into the fastener on the floor.
Jack Hold Down Fastener
373
6