RAM 2500 2020 Owner's Manual page 20

18 GETTING TO KNOW YOUR VEHICLE
START/STOP ignition button, with your foot
applied on the brake pedal, and push to operate
the ignition switch.
Keyless Push Button Ignition
1 — OFF
2 — ACC (Accessory)
3 — ON/RUN
The push button ignition can be placed in the
following modes:
OFF
The engine is stopped.

Some electrical devices (e.g. Central locking,

alarm, etc.) are still available.
ACC
Engine is not started.

Some electrical devices are available.

RUN
Driving position.

All the electrical devices are available.

START
The engine will start.

WARNING!
When exiting the vehicle, always remove

the key fob from the vehicle and lock your
vehicle.
Never leave children alone in a vehicle, or

with access to an unlocked vehicle.
Allowing children to be in a vehicle unat-

tended is dangerous for a number of
reasons. A child or others could be seriously
or fatally injured. Children should be
warned not to touch the parking brake,
brake pedal or the gear selector.
WARNING! (Continued)
Do not leave the key fob in or near the

vehicle, or in a location accessible to chil-
dren, and do not leave the ignition of a
vehicle equipped with Keyless Enter-N-Go
in the ON/RUN mode. A child could operate
power windows, other controls, or move the
vehicle.
Do not leave children or animals inside

parked vehicles in hot weather. Interior
heat build-up may cause serious injury or
death.
An unlocked vehicle is an invitation for
thieves. Always remove key fob from the
vehicle and lock all doors when leaving the
vehicle unattended.
The engine only runs in the ON/RUN ignition
position or from a remote start request.
In case the ignition switch does not change with
the push of a button, the key fob may have a low
or depleted battery. In this situation, a back up
(Continued)
method can be used to operate the ignition
switch. Put the nose side (side opposite of the
CAUTION!