RAM 2500 2020 Owner's Manual page 210

208 SAFETY
NOTE:
If there are child seats in both of the outboard
(left and right) seating positions, the tether
strap hooks of both child seats should be
connected to the center tether strap loop. This
is the correct way to tether two outboard child
seats.
Center Seat:
1. Raise the head restraint and reach
between the rear seat and rear glass to
access the tether strap loop.
Tether Strap Loop With Head Restraint In
Raised Position
2. Place a child restraint on the seat and
adjust the tether strap so that it will reach
over the seat back, under the head
restraint, through the tether strap loop
behind the seat and over to the tether strap
loop behind either the right or left outboard
seat.
3. Pass the tether strap hook under the head
restraint behind the child seat, though the
tether strap loop behind the seat and over
to the right or left outboard tether strap
loop.
Tether Strap Through Center Tether Strap Loop
4. Attach the hook to the outboard tether strap
loop (see diagram). Tighten the tether strap
according to the child seat manufacturer's
instructions.
Tether Strap Through Center Tether Strap Loop And
Attached To Outboard Tether Strap Loop
Installing Three Child Restraints:
1. Place a child restraint on each outboard
rear seat. Route the tether straps following
the directions for right and left seating
positions, above.
2. Attach both hooks to the center tether strap
loop, but do not tighten the straps yet.
3. Place a child restraint on the center rear
seat. Route the tether strap following the
directions for the center seating position,
above.
4. Attach the hook to the outboard tether strap
loop.