RAM 2500 2020 Owner's Manual page 38

36 GETTING TO KNOW YOUR VEHICLE
Power Lumbar — If Equipped
Vehicles equipped with power driver or
passenger seats may also be equipped with
power lumbar. The power lumbar switch is
located on the outboard side of the power seat.
Push the switch forward to increase the lumbar
support. Push the switch rearward to decrease
the lumbar support.
Lumbar Control Switch
Easy Entry/Exit Seat
This feature provides automatic driver's seat
positioning to enhance driver mobility when
entering and exiting the vehicle.
The distance the driver's seat moves depends
on where you have the driver's seat positioned
when you place the ignition in the OFF position.
When you place the ignition in the OFF posi-

tion, the driver's seat will move about
2.4 inches (60 mm) rearward if the driver's
seat position is greater than or equal to
2.7 inches (67.7 mm) forward of the rear
stop. The seat will return to its previously set
position when you place the ignition into the
ACC or RUN position.
When you place the ignition in the OFF position,

the driver's seat will move to a position
0.3 inches (7.7 mm) forward of the rear stop if
the driver's seat position is between 0.9 inches
and 2.7 inches (22.7 mm and 67.7 mm)
forward of the rear stop. The seat will return to
its previously set position when you place the
ignition to the ACC or RUN position.
The Easy Entry/Easy Exit feature is disabled

when the driver's seat position is less than
0.9 inches (22.7 mm) forward of the rear
stop. At this position, there is no benefit to
the driver by moving the seat for Easy Exit or
Easy Entry.
When enabled in Uconnect Settings, Easy Entry
and Easy Exit positions are stored in each
memory setting profile. Refer to "Driver Memory
Settings — If Equipped" in this chapter for
further information.
NOTE:
The Easy Entry/Exit feature is not enabled when
the vehicle is delivered from the factory. The
Easy Entry/Exit feature is enabled (or later
disabled) through the programmable features
in the Uconnect system. Refer to "Uconnect
Settings" in "Multimedia" for further informa-
tion.