Warning Lights And Messages; Red Warning Lights - RAM 2500 2020 Owner's Manual

130 GETTING TO KNOW YOUR INSTRUMENT PANEL
The battery was recently replaced and was

not charged completely.
The battery was discharged by an electrical

load left on when the vehicle was parked.
The battery was used for an extended period

with the engine not running to supply radio,
lights, chargers, +12 Volts portable appli-
ances like vacuum cleaners, game consoles
and similar devices.
What to do when an electrical load reduction
action message is present ("Battery Saver On"
or "Battery Saver Mode")
During a trip:
Reduce power to unnecessary loads if

possible:
Turn off redundant lights (interior or

exterior).
Check what may be plugged in to power

outlets +12 Volts, 115 Volts AC, USB
ports.
Check HVAC settings (blower, tempera-

ture).
Check the audio settings (volume).

After a trip:
Check if any aftermarket equipment was

installed (additional lights, upfitter electrical
accessories, audio systems, alarms) and
review specifications if any (load and Ignition
Off Draw currents).
Evaluate the latest driving cycles (distance,

driving time and parking time).
The vehicle should have service performed if

the message is still present during consecu-
tive trips and the evaluation of the vehicle
and driving pattern did not help to identify the
cause.

WARNING LIGHTS AND MESSAGES

The warning/indicator lights will illuminate in
the instrument panel together with a dedicated
message and/or acoustic signal when
applicable. These indications are indicative and
precautionary and as such must not be
considered as exhaustive. Always refer to the
information in this chapter in the event of a
failure indication. All active telltales will display
first if applicable. The system check menu may
appear different based upon equipment
options and current vehicle status. Some
telltales are optional and may not appear.
R W L
ED ARNING IGHTS
Seat Belt Reminder Warning Light
This warning light indicates when the
driver or passenger seat belt is
unbuckled. When the ignition is first
placed in the ON/RUN or ACC/ON/
RUN position and if the driver's seat belt is
unbuckled, a chime will sound and the light will
turn on. When driving, if the driver or front
passenger seat belt remains unbuckled, the
Seat Belt Reminder Light will flash or remain on
continuously and a chime will sound.
Refer to "Occupant Restraint Systems" in
"Safety" for further information.
Air Bag Warning Light
This warning light will illuminate to
indicate a fault with the air bag, and
will turn on for four to eight seconds
as a bulb check when the ignition is
placed in the ON/RUN or ACC/ON/RUN
position. This light will illuminate with a single
chime when a fault with the air bag has been
detected, it will stay on until the fault is cleared.
If the light is either not on during startup, stays