RAM 2500 2020 Owner's Manual page 150

Hide thumbs Also See for 2500 2020:
Table of Contents

Advertisement

148
SAFETY
Full Off — If Equipped
This mode is intended for off-highway or
off-road use only and should not be used on any
public roadways. In this mode, TCS and ESC
features are turned off. To enter the "Full Off"
mode, push and hold the "ESC OFF" switch for
five seconds while the vehicle is stopped with
the engine running. After five seconds, a chime
will sound, the "ESC OFF Indicator Light" will
illuminate, and the "ESC OFF" message will
display in the instrument cluster. To turn ESC on
again, momentarily push the "ESC OFF" switch.
NOTE:
System may switch from ESC "Full Off" to
"Partial Off" mode when vehicle exceeds a
predetermined speed. When the vehicle speed
slows below the predetermined speed the
system will return to ESC "Full Off".
ESC modes may also be affected by drive
modes (if equipped).
WARNING!
In the ESC "Full Off" mode, the engine
torque reduction and stability features are
disabled. Therefore, enhanced vehicle
stability offered by the ESC system is
unavailable. In an emergency evasive
maneuver, the ESC system will not engage
to assist in maintaining stability. ESC "Full
Off" mode is intended for off-highway or
off-road use only.
The Electronic Stability Control (ESC)
cannot prevent the natural laws of physics
from acting on the vehicle, nor can it
increase the traction afforded by prevailing
road conditions. ESC cannot prevent all
accidents, including those resulting from
excessive speed in turns, driving on very
slippery surfaces, or hydroplaning. ESC also
cannot prevent collisions.
ESC Activation/Malfunction Indicator Light
And ESC OFF Indicator Light
The "ESC Activation/Malfunction
Indicator Light" in the instrument
cluster will come on when the ignition
is turned to the ON mode. It should go
out with the engine running. If the "ESC
Activation/Malfunction Indicator Light" comes
on continuously with the engine running, a
malfunction has been detected in the ESC
system. If this light remains on after several
ignition cycles, and the vehicle has been driven
several miles (kilometers) at speeds greater
than 30 mph (48 km/h), see an authorized
dealer as soon as possible to have the problem
diagnosed and corrected.
The "ESC Activation/Malfunction Indicator
Light" (located in the instrument cluster) starts
to flash as soon as the tires lose traction and
the ESC system becomes active. The "ESC
Activation/Malfunction Indicator Light" also
flashes when TCS is active. If the "ESC
Activation/Malfunction Indicator Light" begins

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

3500 2020

Table of Contents