Table of Contents
Advertisement
272
IN CASE OF EMERGENCY
REINSTALLING THE JACK AND
TOOLS
1. Tighten the jack all the way down by turning the jack
turn-screw counterclockwise until the jack is snug.
2. Position the jack and tools into bracket assembly.
Make sure the lug wrench is under the jack near the
jack turn-screw. Snap tools into bracket assembly
clips. Install the jack into bracket assembly and turn
the jack turn-screw clockwise until jack is snug into
bracket assembly.
Jack And Tools Bracket Assembly
3. Place the jack and tool bracket assembly in the stor-
age position holding the jack by the jack turn-screw,
slip the jack and tools under the seat so that the
bottom slot engages into the fastener on the floor.
Jack Hold Down Fastener
NOTE:
Ensure that the jack and tool bracket assembly
slides into the front hold down location.
4. Turn the wing bolt clockwise to secure to the floor
pan. Reinstall the plastic cover.
Wing Bolt/Jack And Tools
HUB CAPS/WHEEL COVERS —
IF EQUIPPED
The hub caps must be removed before raising the
vehicle off the ground.
CAUTION!
Use extreme caution when removing the front and
rear wheel covers. Damage can occur to the center
cap and/or the wheel if screwdriver type tools are
used. A pulling motion, not a pry off motion, is recom-
mended to remove the caps.
For 2500/3500 Single Rear Wheel (SRW) models, use
the flat end of the lug wrench to hook and pull off the
hub cap. Find the opening in the hub cap, insert the lug
wrench, and pull off the cap. If you need to pry against
the wheel, protect the wheel surface.
Lug Wrench Insertion Location — Hub Cap
On 3500 models with Dual Rear Wheels (DRW), you
must first remove the hub caps—use the procedure
noted for the single rear wheel. For the wheel covers
Advertisement
Table of Contents
