Sata Dom Power Jumper; Figure 35: Sata Dom Power Jumper Diagram; Table 31: Sata Dom Power Jumper Settings - VIA Technologies VB7009 User Manual

3.3. SATA DOM Power Jumper

The SATA connectors (see page 18) can be used to support Disk-on-Module (DOM) flash drives. The
power for SATA DOM is controlled by the jumper labeled as "J2". When the jumpers are set, +5V will be
th
delivered to the 7 pin of the SATA connectors. The jumper settings are shown below.

Figure 35: SATA DOM power jumper diagram

Table 31: SATA DOM power jumper settings

Note:
The default settings of "SATA DOM Power Jumper": short pin 3&5 and pin 4&6
SATA1 Settings Pin 1
DOM support Short
Regular (default) Open
SATA2 Settings Pin 2
DOM support Short
Regular (default) Open
VIA VB7009 User Manual
Pin 3 Pin 5
Short Open
Short Short
Pin 4 Pin 6
Short Open
Short Short
35