3.1. Clear CMOS Jumper
The VIA VB7009 comes with a Clear CMOS jumper. The onboard CMOS RAM stores system configuration
data and has an onboard battery power supply. To reset the CMOS settings, set the jumper on pins 2 and
3 while the system is off. Return the jumper to pins 1 and 2 afterwards. Setting the jumper while the
system is on will damage the board. The default setting is "Short" pins 1 and 2.
Figure 31: Clear CMOS jumper diagram
Table 27: Clear CMOS jumper settings
Note:
Except when clearing the RTC RAM, never remove the cap from the Clear CMOS jumper default position.
Removing the cap will cause system boot failure. Avoid clearing the CMOS while the system is on; it will
damage the board.
Setting
Pin 1
Regular (default)
Short
Clear CMOS
Open
VIA VB7009 User Manual
Pin 2
Pin 3
Short
Open
Short
Short
31