Sata Dom Voltage Select Jumper - VIA Technologies VB7009 User Manual

3.3. SATA DOM Voltage Select Jumper

The SATA connectors (see page 23) can be used to support Disk-on-Module (DOM) flash drives.
When the jumpers are set, +5V will be delivered to the 7
jumper is labeled as "J2". The jumper settings are shown below.
Figure 34 Figure Figure Figure 34 34 34: SATA DOM voltage select jumper : SATA DOM voltage select jumper : SATA DOM voltage select jumper : SATA DOM voltage select jumper
Table Table Table Table 31 31: SATA DOM voltage select jumper settings 31 31 : SATA DOM voltage select jumper settings : SATA DOM voltage select jumper settings : SATA DOM voltage select jumper settings
Note: Note: Note: Note:
The default settings of "SATA DOM Voltage Select Jumper": short pin 3&5 and pin 4&6
2
6
1
5
SATA1 Setting SATA1 Setting
SATA1 Setting SATA1 Setting
DOM support
Regular (default)
SATA2 Setting SATA2 Setting
SATA2 Setting SATA2 Setting
DOM support
Regular (default)
th
pin of the SATA connectors. The pin
Pin 1 Pin 1 Pin 3 Pin 3 Pin 5 Pin 5
Pin 1 Pin 1 Pin 3 Pin 3 Pin 5 Pin 5
On On Off
Off On On
Pin 2 Pin 2 Pin 4 Pin 4 Pin 6 Pin 6
Pin 2 Pin 2 Pin 4 Pin 4 Pin 6 Pin 6
On On Off
Off On On
VB7009 User Manual VB7009 VB7009 VB7009 User Manual User Manual User Manual
39