Data Logging - Samson TROVIS 5573 Mounting And Operating Instructions

Communication
− Pressing the rotary pushbutton to confirm 'SP 73' causes the controller settings to be
transferred from the memory module/mini module.
While the data is being exchanged, bars run across the display. When the transfer is com-
pleted, 'I.O.' is displayed. After that, the connection between controller and memory mod-
ule/mini module can be terminated.
Using TROVIS-VIEW (order no. 6661-1014), it is possible to configure all controller settings
on a convenient user interface at the computer and to document these settings.

10.3 Data logging

A data logging module (order no. 1400-9378) saves the following controller data every two
minutes:
− Temperatures measured by the sensors
− Control signals [%]
− Switching states of the pump outputs
The data logging module is plugged into the RJ-45 connector socket located at the side of the
controller.
The controller starts to write over the oldest data as soon the memory of the data logging
module is full after approximately eight days. The current memory capacity of the data log-
ging module can be read in the extended information level under InFo 2 as the second value
in the sequence (range of values: 0 to 6035). Directly after inserting the data logging mod-
ule, data can be first read after the first scanning cycle has been performed.
The data log viewer software allows the data to be viewed in graph format. The USB convert-
er 3 (order no. 1400-9377) is required to connect the data logging module to a computer.
The data log viewer software is supplied together with the USB converter 3.
EB 5573 EN 103