Copying Function; Data Logging - Samson 5824 Mounting And Operating Instructions

Transfer data

10.2.3 Copying function

The memory pen can be used to copy setting data to other Type 5824/5825 Actuator after
the data from the actuator have been transferred to the memory pen.
Note
"Automatically write to memory pen" is reset after data are transferred from the actuator for
the first time.

10.2.4 Data logging

The memory pen-64 allows the following data to be saved:
− Input [%]
− Actuator travel [%]
− Position feedback [%]
− Temperature inside device [°C]
− Torque switch: Actuator stem retracted
− Torque switch: Actuator stem extended
− Position feedback is relative
− Error during operation
− Input signal failure
− Operating direction switch
− Function switch initialization
The data are logged until the memory capacity of the memory pen is full.
Data in the memory pen can be saved to a data logging file using the TROVIS-VIEW soft-
ware.
Data logging
1. Plug the memory pen into the serial interface of the actuator (Fig. 18).The yellow LED on
the actuator indicates that the data logging is being prepared.
On
Off
1.4
68
2.8 4.2 5.6 7.0 8.4 Time [s]
EB 5824-2 EN