Setting The Party Mode - Samson TROVIS 5573 Mounting And Operating Instructions

Operation

2.7 Setting the party mode

Using the Party mode function, the controller continues or activates the rated operation of the
controller during the time when the party timer is active, regardless of the programmed
times-of-use. After the party timer has counted down, the party time function is reset to
00:00
Parameters
Continue/activate rated
operation
Proceed as follows:
1. Turn the rotary switch to
blinks.
In the systems Anl 1.0, 1.9 and 3.5, 00:00 or the remaining time of the party time are
displayed. The following steps 2 and 3 (to select the control circuit) are not required.
2. Select the control circuit in which day mode is to be activated or continued [q]:
1: Heating circuit 1
2: Heating circuit 2
3: DHW circuit
Only those control circuits are available for selection which can be controlled by the se-
lected system.
3. Confirm the selected control circuit [Û].
Reading: 00:00 or the remaining time of the party time
4. Extend day mode as required [q].
The time is set in steps of 15 minutes.
5. Turn the rotary switch back to normal switch position
Note
The party timer runs down in steps of 15 minutes.
16
WE Value range
0 h 0 to 48 h
(party mode).
(information level).
EB 5573 EN