Configuration; Edid; Hdcp - Extron electronics FOX3 T 301 User Manual

Configuration

NOTE: Transmitters and receivers can be configured via PCS (see the FOX3 T/R 301

EDID

The FOX3 uses EDID Minder, which ensures that a source device connected to the
transmitter input continuously sees the EDID of a sink device, even if the sink is not
physically connected. By default, the EDID is set to 1080p @ 60 Hz with 2-channel audio.
There is one slot to upload custom EDID to the device.
Use PCS to upload EDID to the device (see the FOX3 T/R 301 and FOX3 T/R 311 Help File).

HDCP

Input
The HDMI input negotiates and authenticates HDCP with the source device if the source
requires HDCP encryption. The authentication process is repeated whenever the stored
EDID is changed or updated, which is indicated by pulling HPD low.
HDCP support can be disabled for each input independently using SIS command
(see
FOX3 T/R 311 Help File).
Outputs
The output is pre-authenticated and encrypted, in accordance with the configured HDCP
output mode using PCS (see the FOX3 T/R 301 and FOX3 T/R 311 Help File).
If an output requires encryption, but the connected sink device cannot be authenticated,
that output displays a green screen.
HDCP output modes
•
•
•
•
•
and FOX3 T/R 311 Help File) and SIS commands (see
Control starting on page 23). Product help files are available in PCS when a device
is connected or an offline device is selected.
HDCP authorized device
Follow Input (default) — Output authentication and encryption follows input status.
Authentication times out after ~10 seconds.
Always Encrypt Output — The output is always authenticated and encrypted.
Authentication times out after ~10 seconds.
Follow Input (with continuous trials) — Output authentication and encryption follows
input status with no authentication timeout.
Always Encrypt Output (with continuous trials) — The output is always
authenticated and encrypted with no authentication timeout.
Disable Authentication — The output is never authenticated or encrypted. When an
HDCP encrypted input signal is detected, the display always shows a green screen.
FOX3 T/R 301/311 Transmitters and Receivers • Installation and Operation
SIS Configuration and
on page 31) or PCS (see the FOX3 T/R 301 and
20