Simple Instruction Set Control; Host-To-Unit Instructions; Device-Initiated Power-Up Message; Error Responses - Extron electronics FOX3 T 301 User Manual

Using verbose mode
SSH connections to a FOX3 device can be used to monitor for changes that occur on the
device, such as SIS commands from other SSH sockets or a serial port. For a SSH session
to receive change notices from the device, the SSH session must be in verbose mode 1 or
3 (see the SIS command

Simple Instruction Set Control

Host-to-Unit Instructions

SIS commands consist of one or more characters per field. No special characters are
required to begin or end a command character sequence. When a command is valid, the
transmitter executes the command and sends a response to the host device. All responses
from the transmitter to the host end with a carriage return and a line feed (CR/LF =
which signals the end of the response character string. A string is one or more characters.

Device-Initiated Power-Up Message

When the device completes its start‑up, it issues the following message to the host:
© Copyright 20yy, Extron Electronics FOX3 T (R) 301 (311) MM (SM), Vx.xx, 60‑nnnn‑nn
•
•

Error Responses

When the transmitter receives a valid SIS command, it executes the command and sends a
response to the host device. If the transmitter is unable to execute the command because
the command is invalid or it contains invalid parameters, the transmitter returns an error
response to the host. The error response codes are:
•
•
•
•
•
•
NOTES:
The FOX3 device is shipped password‑protected. The factory configured
•
passwords for all accounts on this device have been set to the device serial
number.
• In the event of a complete system reset, the password converts to the default,
which is extron. New passwords must be configured to secure the device.
On password‑protected connections, there are two levels of protection:
•
administrator and user. Administrators have full access to all switching
capabilities and editing functions. Users can create ties, create and recall
presets, set mutes, and view all settings with the exception of passwords.
Verbose mode
Vx.xx is the firmware version number
60‑nnnn‑nn is the part number.
E10 — Invalid command
E11 — Invalid preset number
E13 — Invalid parameter
E14 — Invalid for this configuration
E17 — Invalid command for signal type
E18 — System or command timed out
FOX3 T/R 301/311 Transmitters and Receivers • SIS Configuration and Control
on page 30).
E21 — Invalid room number
•
E22 — Busy
•
E24 — Privilege violation
•
• E25 — Device not present
E26 — Maximum number of connections
•
exceeded
E28 — Bad file name or file not found
•
]
),
26