Extron electronics FOX3 T 301 User Manual page 17

SFP module and LEDs — (see
K
WARNING: The units output continuous invisible light (Class 1 rated), which may be
harmful to the eyes; use with caution. Plug the attached dust cap into the optical
transceiver when the fiber optic cable is unplugged.
AVERTISSEMENT : Le produit émet une lumière invisible en continu (conforme
à la classe 1) qui peut être dangereux pour les yeux, à utiliser avec précaution
Branchez la protection contre la poussière dans l'ensemble émetteur/récepteur
lorsque le câble fibre optique est débranché.
NOTES:
• Ensure the proper fiber cables for the transmitter and receiver pair are used.
Typically, singlemode fiber has a yellow jacket and multimode cable has an
orange or aqua jacket.
• See figure 3 for fiber cable connections. Connect the transmitter to a receiver in
one of three ways:
One way (transmitter to receiver) only, connect transmitter Outputs A (
•
receiver Inputs A (
Two way (transmitter to receiver and return), connect transmitter Outputs
•
A ( ) to receiver Inputs A (
1
receiver Inputs A (
• Output B is available to transmit a 4K @ 60 Hz uncompressed signal when
the FOX3 4K @ 60 Hz Uncompressed Video LinkLicense is purchased.
Port A Out (required) — For all one-way video, audio,
1
and serial communications from the transmitter to the
receiver, connect a fiber optic cable to the Out LC port.
Connect the opposite end of this fiber optic cable to
the Port A In LC port on the receiver (see figure 4,
on page 10) or to any other compatible Extron FOX3
device.
Port A In (optional) — For one-way return audio, USB,
2
and serial communications from the receiver to the
transmitter, connect a fiber optic cable to the In LC port.
Connect the opposite end of this fiber optic cable to the
Port A Out LC port on a receiver (see figure 4,
any other compatible Extron FOX3 device.
SFP Link LEDs —
• Transmit Optical OUT LED lights solid green when powered and lights off when
there is no power on the endpoint.
Receive Optical IN LED lights solid green when light is present and lights off when
•
there is no power or light present.
Reset button — Initiates three levels of resets (1, 4, and 5). Use a pointed stylus,
L
ballpoint pen, or small screwdriver to access the recessed button (see
page 18 for detailed reset information).
FOX3 T/R 301/311 Transmitters and Receivers • Installation and Operation
figure 2 on page 7)
).
1
) and connect transmitter Outputs A (
1
).
2
) or to
J
) to
1
) to
2
OUTPUTS
A B
OUT IN OUT IN
Transmitter
1 1 2 2
J
2 2 1 1
INPUTS
A B
Receiver
OUT IN OUT IN
Figure 3. Connection
Reset on
9