Receiver Rear Panel Connections - Extron electronics FOX3 T 301 User Manual

Receiver Rear Panel Connections

NOTE: Figure 4 shows the FOX3 R 301 receiver. The FOX3 R 311 looks similar, with the
exception of the USB ports (
~
100-240V 0.7A MAX
60-60 Hz
A A A B B B
Figure 4.
Power inlet
A
Power LED
B
Audio Return
C
Audio output
D
Power inlet — Plug a standard IEC power cord into this connector to connect the unit
A
to a 100 VAC to 240 VAC, 50-60 Hz power source.
Power LED — The lit LED indicates power is applied.
B
Audio Return — Connect a balanced or unbalanced audio input to this 3.5 mm,
C
5-pole captive screw connector for return to the transmitter (see
Connectors
Audio output — This 5-pole, 3.5 mm captive screw connector outputs the transmitted,
D
unamplified, line level analog audio (see
connector).
NOTE: If embedded digital audio is present on the HDMI output, these analog audio
connectors do not output audio unless forced to so by an SIS command (see
Input audio selection
USB Hub ports — (see
E
• USB HID — Connect USB type A to B cables between this USB type B port
and the USB port of a device. The USB HID ports are used only for a mouse or
keyboard.
• USB 2.0 (FOX3 R 301 only) — Connect USB type A to B cables between this USB
type B port and the USB port of a device. The USB 2.0 ports are used for thumb
drives, cameras, keyboards, a mouse, CAC reader, and such devices.
HDMI output — Connect a video display to this HDMI output port with a maximum
F
resolution of 4096x2160 @ 60 Hz, 8-bit, 4:4:4 chroma sampling (see
Connectors
H ). It has no USB 2.0 port.
OUTPUTS
L R
DEVICES
USB HID
1
AUDIO
USB 2.0
L R
2 1
100 mA
500 mA
J
C C C D D D E E E F F F
FOX3 R 301 Receiver Rear Panel Connectors
USB Hub ports
E
HDMI output
F
Remote RS-232/3D Sync port
G
Control RS-232/IR port
H
on page 14 to wire this connector).
on page 31).
USB HID and USB 2.0 Connectors
on page 13 to use the included Extron Lock-It Lacing Bracket).
FOX3 T/R 301/311 Transmitters and Receivers • Installation and Operation
RS-232 IR
Tx Rx G Tx Rx
INPUTS
A
REMOTE 3D
LAN
SYNC
RS-232
HDMI Tx Rx G S 5V
OUT IN
G G G H H H I I I J J J
I
J
K
Analog Audio Connectors
B
R
OUT IN
K K K
LAN Ethernet port
SFP module and LEDs
Reset button
Analog Audio
to wire this
on page 16)
HDMI
10