Peku Installation Procedure - Toshiba Strata DK 16 Installation And Maintenance Manual

CONTROL/INDICATOR/
CONNECTOR (Figure 5-13)
Off-hook Call
Announce P10
Off-hook Call
Announce P20
Off-hook Call
Announce P40
Off-hook Call
Announce P50
Off-hook Call
Announce P60
DSS/EKT DSS Console/
Electronic Telephone
SW1 Switch
BGM source connection
W5 Jumper Wire
8.14 Background Music (BGM) Configuration.
Configure the PEKU to support a BGM source in
accordance with the following steps:
1) Remove the PCB from its protective pack-
aging.
2) Cut the W5 (BGM) jumper wire on the PEKU
PCB.
3) Refer to Peripherals Installation, Section 100-
816-207, for installation procedures for BGM
connection.
TABLE 5-B
PEKU CONTROLS AND INTERFACE CONNECTORS
TYPE OF COMPONENT
10-pin connector
10-pin connector
10-pin connector
10-pin connector
10-pin connector
Two-position slide switch
White jumper wire
5-19
INSTALLATION-DK 16 KSU & PCB
DESCRIPTION
Interface connector for optional Off-hook
Call Announce subassembly
connector (used in conjunction with P20,
P40, P50, and P60).
Interface connector for optional Off-hook
Call Announce subassembly
connector (used in conjunction with P10,
P40, P50, and P60).
Interface connector for optional Off-hook
Call Announce subassembly
connector (used in conjunction with P10,
P20, P50, and P60).
Interface connector for optional Off-hook
Call Announce subassembly
connector (used in conjunction with P10,
P20, P40, and P60).
Interface connector for optional Off-hook
Call Announce subassembly
connector (used in conjunction with P10,
P20, P40, and P50).
Configures PEKU for operation with either
an HDSS console or electronic
telephones.
When cut, configures PEKU for BGM
source connection.
8.15 External Amplifier Configuration. The
PEKU does not have to be configured to support an
external amplifier. However, the system must be
programmed for one; see Paragraph 8.40. See
Peripherals Installation, Section 100-816-207, for
external amplifier installation instructions.

8.20 PEKU Installation Procedure

8.21 Install the PEKU in accordance with the fol-
lowing steps:
1) Remove the PCB from its protective pack-
aging.
SECTION 100-816-205
MARCH 1993