Toshiba Strata DK 16 Installation And Maintenance Manual page 316

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
STEP
1 Enter the Test Mode
At the >MODE prompt, enter T E S T CR.
2 To Check Station Line Status
Enter S E K T X X (X X = port number).
Possible status: Idle on-hook, idle off-hook, busy on-hook,
busy off-hook.
To prevent service interference, station line status must be
idle on-hook before initiating a test from that station.
3 To Check CO Line Status
Enter S C O Y Y (Y Y = CO line number).
Possible status: Idle, busy.
4 To Exit the Test Mode
At the T prompt, enter Q U I T CR.
STEP
1 Enter the Test Mode
At the >MODE prompt, enter T E S T CR.
2 To Activate A Button
Enter T K X X K Y Y CR.
XX = Port number and YY = button number.
NOTE: Button numbers begin at 01.
3 To Activate A Function Button
Enter T K X X F CR F = function button designator
SPKR
HOLD
CONF
MIC
4 To Access A CO Line (via CO Access Code) and Dial Out
Enter T K X X K 0 1 A A A
AAA = 1, 2, or 3-digit CO line access code and
= telephone number.
5 To Access A CO Line (via CO Line Button) and Dial Out
Enter T K X X K Y Y
YY = CO line number.
6 To Exit the Test Mode
At T prompt, enter Q U I T CR.
TABLE RM-BS
STATION/CO LINE STATUS CHECK
ACTION
IMPORTANT!
TABLE RM-BT
GENERAL STATION ACCESS AND BUTTON ACTIVATION
ACTION
S
H
F = S, H, C, M
C
M
CR.
Telephone Number
>MODE TEST
T SEKT XX IDLE ON-HOOK
T
T SCOYY – BUSY
T
T QUIT
> MODE
>MODE TEST
T
T TKXX KYY
T
TTKXX F
T
TTKXX K01 AAA
CR.
T
TTKXX KYY
T
-66-
DISPLAY/PRINTOUT
DISPLAY/PRINTOUT