Toshiba Strata DK 16 Installation And Maintenance Manual page 309

STEP
1 Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 Enter Program Number 55
Press CR.
3
Enter Modified Digits Table Number
Refer to the System Record Sheet and enter the required
modified digits table number (1 ~ 6).
Example: Enter table number 1, enter 1.
4 Enter Code 2
The system will display any previously entered digits (up to 22).
Refer to the System Record Sheet and enter new numbers,
if required.
Example: Enter 1 2 3 4 P 3.
NOTE: Pause codes may also be entered. To enter pauses,
press "P" plus the pause number (1 ~ 8).
Special Code Input
Pause = P 1 ~ P 8.
Tone = T at beginning of digits to convert.
C as first digit, then CR.
Clear =
5 To Exit Program/Store Data
A) To store data, press CR.
B) Continue returning to step 3 until all data has been entered
for this program.
C) To exit this program, press # # CR.
REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
TABLE RM-BJ
PROGRAM 55-2
LCR MODIFIED DIGITS-END
ACTION
-59-
SECTION 100-816-600
MARCH 1993
DISPLAY/PRINTOUT
>MODE PROG
P
P 55
P55
P55 1
(up to 22 digits)
P55 12
1 2 3 4 P3
(up to 22 digits)
P55 12
1 2 3 4 P3
P55 ##
P