Toshiba Strata DK 16 Installation And Maintenance Manual page 315

REMOTE CALLED STATION MESSAGING (ADD/CHANGE)
STEP
1 Enter the Message Mode
At the >MODE prompt, enter M E S G CR.
2 To Change or Add a New Called Station Message
Set the terminal keyboard to the lower case (cap lock off) and
enter m 9 6.
NOTE:
Enter "m" (lower case) anytime it is desired to start over
in this procedure.
Enter X X X (XXX = destination station number or destination
3
station group number – 30 = all DKTs/EKTs, 31 ~ 34 per system,
Program 31).
Enter p Y Y Y (p = page command and YYY = originating
4
station number).
5 Enter p (p = page command and
= 2-digit message memory location: 10 ~ 19 personal
messages and 60 ~ 99 = system messages).
6 To Add the New Message [M]
Set the terminal keyboard to upper case and enter message
as required (alphanumeric, 32 characters max.). New message
displays as it is entered.
7 To Set the Message
Set the terminal keyboard to lower case and enter p m 0.
Destination station: Msg LED flashes, "CALL YYYM" is
displayed on LCD.
Origination station: "SENT XXXM" is displayed on LCD.
8 To Exit the Message Mode
At any time, enter m 0 p (lower case).
NOTES:
1. [M] represents the message entered.
2. DKT = digital telephone; EKT = electronic telephone.
REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
TABLE RM-BR
MODE 96
ACTION
-65-
SECTION 100-816-600
MARCH 1993
DISPLAY/PRINTOUT
>MODE MESG
m 96
m96 XXX
m96 XXX p YYY
m96 XXX p YYY p
m96 XXX p YYY p [M]
m96 XXX p YYY p [M] p
m 0
Zero
m 0
q
>MODE