Toshiba Strata DK 16 Installation And Maintenance Manual page 277

STEP
1 Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 Enter Program Number
Refer to the record sheet and enter the desired program number.
Example: Program 30, enter 3 0, press CR.
3 Enter Port Number
Refer to the System Record Sheet and enter the desired
port number(s). Example: 0 4.
4 Press # button.
5 Enter the Desired Button/LED Number
Example: Button/LED 01, enter: 0 1.
6 To Change Button/LED Status
Refer to the System Record Sheet and change the button/LED
status, if required (Y or N).
Example: Enter Y.
7 To Advance to Next Button/LED
Press SPACE (repeat Step 6 if necessary).
8 To Review Button/LED Status Change
Press CR.
Re-enter Steps 3, 4, and 5.
9 To Exit Program/Store Data
To store data, press CR.
A)
B) To exit this program, press # #, then press CR.
C) Continue returning to Step 2 until all Type 2 programs
are completed.
10 To Exit the Program Mode
Press # # CR.
11 To Enter Another Mode,
Press
D U M P CR
T E S T CR
M E S G CR
R E P T CR
NOTE:
Y = button/LED(s) "ON", N = button/LED(s) "OFF"; U = button/LED(s) "ON" some ports and "OFF" other ports.
REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
TABLE RM-R
TYPE 2 PROGRAM PROCEDURE EXAMPLE
(PROGRAMS: 20, 30, 31, 35, 40, 41, 43, 79, 81 ~ 89)
ACTION
*
or Port Range
(data dump)
(test)
(LCD messages)
(speed dial)
-27-
SECTION 100-816-600
MARCH 1993
DISPLAY/PRINTOUT
>MODE PROG
P
P 30
P30
P30 04
P30 04#
P30 04# 01 N
(Note)
P30 04# 01 N Y
P30 04# 01 Y-
LED "ON"
Button LED Number
Port Number
Program Number
P10
P10 ##
P
>MODE
D
T
(no prompt)
R