Button Programming Procedure - Toshiba Strata CIX Programming Manual

FB04
7. Press . Press
FB05
8. Press . Press
FB06
9. Press . Press
FB07
10.Press . Press
##Hold
11. Press
Now that you are more familiar with the Strata CTX button programming interface, begin programming your
Strata CTX system starting with Step 1 below.

Button Programming Procedure

Step 1: Enter Program Mode
Enter the button sequence displayed below to enter the CTX670 programming interface from a DKT
station.
1. Log in by pressing:
2. At the PASSWORD= prompt, enter your password. Default is
Hold
3. Press .
Step 2: Enter Program Number
1. At the PROG= prompt enter the three digit program code (e.g.,
2. Programmable parameters are identified by the FB LEDs that are illuminated on the DKT. Go to
ìChoose a Button Sequenceî
... or if there are no illuminated FB LEDs, continue to Step 3.
Step 3: Enter FB00 Parameters
FB00
parameters designate a specific station, trunk, or circuit to be programmed. The
EQUIP=, DN=, INDEX=, etc.) appears automatically in the LCD screen.
FB00
1. At the prompt, enter the desired value using the telephone number pad.
Hold
2. Press .
Step 4: Choose a Button Sequence
➤
Select the button sequences based on the programs required for programming the Strata CTX from the
Telephone. For 100~900 series programs, refer to pages 11~97.
Program Listings
This table is a list of programs found in this chapter.
Program
Number
100
102
103
104
105
106
Strata CIX/CTX Telephone Button Programming 11/04
60
to set the Hold Recall Timer and press
15
to set the First Interdigit Timer and press
5
to set the Second Interdigit Timer and press
32
to set the Ring Transfer No Answer Timer and press
to return to the PROG= prompt.
Hold ✱#✱#1✱2✱3✱
.
on page 1-7
Card Slot Assignment
Flexible Access Codes
Class of Service
System Timers
System Parameters
Day/Night Mode Day of Week Mapping
Hold
.
Hold
Hold
0000
.
200
) and press
FBnn
Press on the related
Program Name
Telephone Button Programming
Button Programming Procedure
.
.
Hold
twice.
Hold
.
button to program a parameter.
FB00
prompt (e.g.,
1-7