Toshiba Strata DK 16 Installation And Maintenance Manual page 310

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
STEP
1 Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 Enter Program Number 56
Press CR.
3
Enter Port Number
Refer to the System Record Sheet and enter the
required port number,
Example: Port 01, enter 0 1.
4
Press # Key (if single port
The system will display any previously entered group number (1 ~ 4).
Refer to the System Record Sheet and change as required.
Example: Change to 4, enter 4.
5 To Exit Program/Store Data
To store data, press CR.
A)
B) Continue returning to step 3 until all data has been entered
for this program.
To exit this program, press # # CR.
C)
STEP
1 Enter the Data Dump Mode
At the >MODE prompt, enter D U M P CR.
2 To Output Program Data
Enter P R G
= Program number or A L L for all programs.
3 To Stop Printout at Any Time
Enter DELETE CR at the same time.
4 To Exit the Dump Mode
Enter Q U I T CR.
TABLE RM-BK
PROGRAM 56
LCR STATION GROUP ASSIGNMENT
ACTION
*
or .
entry in step 3).
TABLE RM-BL
PROGRAM DATA DUMP
ACTION
CR
>MODE PROG
P
P 56
P56
P56 01
P56 01# 1 4
P56 01# 1 4
P56 ##
P
>MODE DUMP
D
D PROG
D
>MODE
-60-
DISPLAY/PRINTOUT
DISPLAY/PRINTOUT