Toshiba Strata DK 16 Installation And Maintenance Manual page 304

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
LCR OFFICE CODE EXCEPTIONS FOR SPECIFIED AREA CODE
STEP
1 Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 Enter Program Number 52
Press CR.
3 Define Route Plan Number
Refer to the System Record Sheet and enter the
exception table number (1 ~ 8).
Example: Table 1, enter 1.
Enter Action code 0.
The system will print out the currently defined route
plan number. Refer to the System Record Sheet and enter
new plan number if required. Example: Change to 3.
4 Define Area Code Number
Press CR.
Enter exception table number (1 ~ 8) defined in step 3.
Enter Action code 1.
The system will print out the currently defined area
code number. Refer to the System Record Sheet and enter the
new area code number if required.
Example: Change to 212, enter 2 1 2.
Press CR.
5 Display Office Codes
Enter exception table number defined in step 3.
Enter Action code 4.
Press SPACE to display previously selected office codes.
Continually press SPACE until all previously selected
codes have been displayed, then press CR.
6 To Add (2) or Delete (3) Office Codes
Press CR.
Enter exception table number defined in step 3.
Refer to the System Record Sheets and enter 2
to add office codes or 3 to delete office codes.
Example: Add office codes 300-325
Enter 2 (or 3) 3 0 0
7 To Exit Program/Store Data
Data was stored when CR was pressed in step 6.
A)
B) Continue returning to step 3 until all data is entered
for this program.
C) To exit this program.
Press # # CR.
TABLE RM-BE
PROGRAM 52
ACTION
*
3 2 5 CR.
-54-
DISPLAY/PRINTOUT
>MODE PROG
P
P 52
P52
P52 10 3
LCR Plan No.
Action Code
Exception Table No.
P52 11 212
P52
Area Code
Action Code
Exception Table No.
P52 14
Office Codes
P52 12
300-325
P52
P52 ##
P