Toshiba Strata DK 16 Installation And Maintenance Manual page 295

STEP
1 Enter the Program Mode
At the >MODE prompt, enter P R O G CR.
2 Enter Program Number 45
Press CR.
Enter the number 2.
3
4 Refer to the record sheet and enter the required CO line number.
Example: CO line 01, enter 0 1. The system will display
N or Y to define if the LED is on or off.
5 Refer to the System Record Sheet and change the CO line
status as required (Y or N).
Press SPACE to step to next CO line number.
6 To Exit Program/Store Data
A) To store data, press CR.
B) To exit this program, press # # CR.
EQUAL ACCESS, SPECIAL COMMON CARRIER NUMBERS, and AUTHORIZATION CODE DIGIT LENGTH
STEP
1 Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 Enter Program Number 45
Press CR.
3 Refer to the record sheet and enter the item number (3 ~ 6).
Example: Item 3, enter 3. The system will display
the present equal access number or EA1 Code.
4 Refer to the System Record Sheet and enter the required number.
Example: 12345, enter 1 2 3 4 5 CR.
5 Enter code number 4. The system will display present authorization
code digit length. Refer to the System Record Sheet and enter
the required authorization code number digit length.
Example: 12, enter: 1 2 CR.
6 To exit this program, press # # CR.
NOTE:
Items 5 and 6 are entered the same way as 3 and 4, respectively.
REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
TABLE RM-AP
PROGRAM 45-2
TOLL RESTRICTION DISABLE
ACTION
TABLE RM-AQ
PROGRAM 45-3 ~ 6
ACTION
-45-
SECTION 100-816-600
MARCH 1993
DISPLAY/PRINTOUT
>MODE PROG
P
P 45
P45
P45 2
P45 2 01 N
P45 2 01 N Y
02 N
P45 2 01 N Y
02 N
P45 ##
P
DISPLAY/PRINTOUT
>MODE PROG
P
P 45
P45
P45 3 NNNNN
P45 3 NNNNN 12345
P45
P45 4 00 12
P45
P45 ##
P