Toshiba Strata DK 16 Installation And Maintenance Manual page 278

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
STEP
1 Enter the Program Mode
At the >MODE prompt, enter P R O G CR.
2 Enter Program Number 12
Press CR.
3 Check the record sheet and enter the program code that is
required.
As an example, feature 3, enter 3.
The present selection will be displayed.
4 Refer to the record sheet and change if required.
As an example, change it to 2.
Enter 2.
5 To Exit Program/Store Data
To store data, press CR.
A)
B) Continue returning to Step 3 until all Program 12 data is
entered.
To exit this program, press # # CR.
C)
STEP
1 Enter the Program Mode
At the >MODE prompt, enter P R O G CR.
2
Enter Program Number 13
Press CR.
Enter the number 1. The present port number will be displayed.
3
4 Refer to the record sheet and enter the required port number.
Example: Port 00, enter 0 0 CR.
To Exit this Program
5
Press # # CR.
NOTES:
1. A blank is displayed by "N".
2. Programs 15 and 16 use Type 1 procedure.
TABLE RM-S
PROGRAM 12
SYSTEM ASSIGNMENTS – BASIC TIMING
ACTION
TABLE RM-T
PROGRAM 13
DEFINING THE MESSAGE CENTER
ACTION
-28-
DISPLAY/PRINTOUT
>MODE PROG
P
P 12
P12
P12 3 1
P12 3 1 2
P12 3 1 2
P12 ##
P
DISPLAY/PRINTOUT
>MODE PROG
P
P 13
P13
P13
P13 1 NN
P13 1 NN 00
P13
P13 1 NN 00
P13 ##
P