Trips/Faults - Toshiba H9 Installation And Operation Manual

Trips/Faults

A Trip is a H9 ASD response to a Fault (though, Fault and Trip are sometimes used interchangeably). A
Trip is a safety feature that disables the ASD system in the event that a subsystem of the ASD is
malfunctioning or a parameter setting has been exceeded.
Listed in Table 14
incurred the system displays the Fault screen. The Fault screen identifies the active Fault.
A more user-friendly indication of the active Fault will be displayed at the LCD screen.
LED Display LCD Display
E Emergency Off
E-10
Sink/Source Setting
Error
E-11
Brake Sequence
Response Error
E-12
Encoder Signal-Loss
Error
E-13
Over Speed
Key Failure
E-17
E-18
Terminal Input Error
CPU Communication
E-19
Error
E-20
V/f Control Error
E-21 CPU Processing
Error
Logic Input Voltage
E-22
Error
Optional Expansion
E-23
Input Terminal Board
1 Error
250
are the Faults that may result in a Trip and the possible causes. When a Trip is
Table 14
• Emergency Off command received via EOI or remotely.
• Improperly positioned Sink/Source jumper on the Terminal board or on an
option device (see J100 at the Terminal PCB of the ASD).
• Sink/Source configuration is incorrect.
• F630 is set to a non-zero value.
• Braking sequence discrete input and output terminals are not setup properly.
• ASD is configured to receive a signal from a shaft-mounted encoder and no
signal is being received while running.
• Disconnection at the Encoder circuit.
• Motor is stopped and is generating torque via torque limit control.
• ASD is not configured properly.
• Result of a motor speed that is greater than the commanded speed when
using an encoder for speed control.
• Improper encoder connection or setup information.
• Defective encoder.
• Same key input for 20 seconds or more.
• V/I signal loss.
• Terminal Board failure.
• P24 overcurrent condition.
• F633 setting is too high.
• CPU data Transmit/Receive error.
• Torque processing error.
• Make service call.
• Software processed incorrectly.
• Make service call.
• Incorrect voltage applied to the discrete input terminals.
• Optional Expansion Input Terminal Board 1 is defective.
Possible Causes
H9 ASD Installation and Operation Manual