Siemens SIMODRIVE 6SN11 Series Planning Manual page 443

09.00
Continuous speed
The maximum permissible continuous operating speed n
bearing design and the shaft height according to the following table:
Table 1-14
Important
!
If the motor is operated at speeds between n n
with low speeds and standstill intervals is assumed, in order to guarantee that
the grease is distributed in the bearing.
1) mechanical limiting speed (permissible for 10 min cycle with: 3 min n
2) maximum continuous operating speed
3) only coupling out drive permissible
 Siemens AG 2000 All rights reserved
SIMODRIVE Planning Guide Motors (PJM) – 11.00 Edition
Assignment, max. speed to the shaft height and bearing design
Shaft Coupling drive, belt
height drive
[mm]
[RPM]
1) 2)
n n
max s1
100 9000 5500
132 8000 4500
160 6500 3700
180 5000 3500
225 4500 3100
6SN1197–0AA20
1PH7 AC Main Spindle Motors
1.4 Bearing design
depends on the
s1
Belt drive with increa- Increased maximum
sed cantilever force
[RPM]
1) 2)
n n n
max s1 max
– – 12000
– – 10000
– – 8000
5000 3000 7000
4500 2700 5500
and n , a speed duty cycle
s1 max
, 6 min 2/3 n , 1 min standstill)
max max
speed
[RPM]
1) 2)
n
s1
10000
8500
7000
3) 3)
4500
3) 3)
3600
1PH7
1PH7/1-15